############
# SmartCopilot configuration file for HOTSTART TBM 900 (Tested with version 1.08)
# by 	mechia,
#     	teh-spartan
#     	docpan
#	from the smartcopilot config garage
#
#	Special thanks to totorikto for his help
#
### Any modification only with permisson of the authors of these lines... thank you
#
#--------- NOTES: ---------
#
# Please Review The presync Checklist.
# Due to limitations of the G1000, it is important to follow this checklist. because of these limitations 
#
#
#------ Xsquwak USERS: --------
#
# Because of the lack of observer mode
# The transponder fuses (1&2) are not synced. 
# and the pilot with the Observer Call-sign 
# should Pull these fuses to turn off their.
# transponder
#
### Version 1 : 	Initial Version 


#### Install ####

1. Put the smartcopilot file into the main Folder of the Hotstart TBM 900

2. Rename your TBM900 Folder in Xplane 11/Output to TBM900_my (or what ever you like) to keep your airframes

3. Put the TBM900 folder from this file in Xplane 11/Output

3. Load Xplane

4. Load the Hotstart TBM900

5. Do the ckecklist in this file (for this plane it more essential then ever to have the same status at the beginning)

6. Do the Payload stuff before connect individual (because these stuff are not synct at the moment)

7. connect via smartcopilot  

Have fun :)


Until we dont have the option for cold and dark, these steps are important to get and same status at the beginning of the sharing flight. Later when have the option this becomes more esay ;)

---------------------------------------------------------------------------------------------------------------------------

## How to make your own cold dark TBM900 folder ##

1 Make a fresh installation of the TBM900.

2.Skip the Intro and open the pilots door.

3.Quit Xplane

4.Go to Xplane 11/Output and copy/save the TBM900 folder. This folder contains your cold and dark airframe you will use for smartcopilot. 
 