SmartCopilot Config File for the AFM OVIII
Here is my Smart Copilot Config file for the AFM OVIII Currently Requires Testing But I think Im pretty Close!!
What Should Be Synced
- Pilot & Copilot
Every Switch & Circuit breaker
Both GN1000 Panels
Autopilot (Please Test this)
Circuit Breakers Popping
- Pilot Only (Who Has Control)
Flight Controls (if it can alter the Speed and Attitude Directly)
Alternate Air Sources
Static Objects (Pilots Responsibility to remove Covers Etc)
Engine Fuel Flow
Current Time of Day
The Basic Setup :
The config file is set to refresh the weather every 2 hours NOAA where X-plane gets its weather is only updated every hour at 10 past the hour. Personally I would set the same in Xplane.
Both set the aircraft same location (including Gate) Cold and dark cockpit (All Switches off)
Master initializes the connection the time of day and weather will be sent as soon as your connected (give it a couple of seconds to update) you should then be good to go!!
Just to stop any problems I would recharge the batteries, refill the oxygen and TKS prior to Connection.
Again please comment on any bugs you find And Enjoy!!!